Use Of The Appliance - ALPATEC HU 60.1 ET Mode D'emploi

All manuals and user guides at all-guides.com
notice_hu60.1_et 29/03/07
• At first use let the appliance half an hour in the room before using so that the moisture sensor is
completely efficient.
• The best working environment for the humidifier is : temperature between 5°C and 40°C and moisture
less than 80% HR.
• Clean the water tank as well as the water flume before first use and after no use for long time.
• This product is equipped with a descaling cartridge which has to be cleaned every two months or
when white dust appears on the cartridge.
ASSEMBLY OF THE APPLIANCE
• Get out the water tank from the base. Unscrew the water tank cap located under the tank. Fill the
tank with water (water temperature should be less than 40°C). Screw tightly the tank cap and replace
the water tank on the base. Replace the cap of the mist spray mouth (1).
ALL FUNCTIONS ARE AVAILABLE WITH THE REMOTE CONTROL.
ON/OFF :
• Press M/A key (16), the appliance begins working and operating light indicator lights on. Press the
key again and the appliance stops working.
"MOISTURE +" :
• this key (15) allows you to choose moisture level
• Press this key to choose moisture rate. (levels : 20% ; 25% ; 30% ... 85% ; 90%)
• The screen flashes during 5 seconds then shows ambient moisture. If ambient moisture level is up to
the moisture level preselected the appliance stops automatically working.
" MOISTURE – ":
• key (14)
• This function is the same as "Moisture +" in opposite order : 90% ; 85% ; 80% ... 25% ; 20%)
IONIZER FUNCTION :
• In generating negative ions, the ioniser function allows to restore air electric balance. Its activation
gives a well-being sensation, above all a cocooning atmosphere.
• Press Ionizer key (13), ionizer function is operating. Ionizer indicator flashes on the screen.
(See photo below)
• Press the key again to stop ionizer function. Indicator goes out.
ionizer function
indicator
12:21 Page 9

USE OF THE APPLIANCE

USE OF THE APPLIANCE
9