Use Of The Appliance; Cleaning And Maintenance - ALPATEC HU 45.1 E Mode D'emploi

All manuals and user guides at all-guides.com
notice_HU45.1E 18/04/06
- Unscrew the nut cap, fill the water box with cold and clean water (do not use hot water).
- Press M/A key, the appliance begins working and operating light indicator lights on.
Mode I is automatically choose.
- Press Mode key, Mode function will be alternatively changed from
estate I (means constant mist),
to estate II (means that the mist sprays during 1 minute and stops during 1 minute),
to estate III (means that the mist prays during 1 minute and stops during 3 minutes).
- Press timer key to program the appliance from 1 hour to 7 hours.
- Ionizer function : In generating negative ions, the ioniser function allows to restore air electric
balance. Its activation gives a well-being sensation, above all a cocooning atmosphere.
- Press Ionizer key, ionizer function is operating. Ionizer indicator flashes on the screen.
Press the key again to stop ionizer function. Indicator goes out.
- Press M/A key to stop the appliance. The appliance is automatically cut off when waterless.
• The best working environment for the humidifier is : temperature between 5°C and 40°C and moisture
less than 80% HR.
• Clean the water tank as well as the water flume before first use and after no use for long time.
• This product is equipped with a descaling cartridge which has to be cleaned every two months or
when white dust appears on the cartridge.
• Clean the transducer with descaling detergent. Get out the water tank from the base, empty the base
and drop 10 ml of descaling detergent on the transducer.
• Wait about 2 to 5 minutes then wash with a brush and rinse plentifully with clear water.
• Clean the water tank with a little soft detergent and half of the tank of water. Screw the tank cap and
shake it up and down several times, and then use water to rinse.
• If there is waste left in water flume, clean it with a damp cloth and detergent, then rinse with water.
• If the humidifier has not been working for a long time, clean it as described above.
• Cleaning of the descaling cartridge : take out the cartridge and soak it into salt liquid (one big spoon
of salt in a glass of water) for about 60 minutes. Rinse with clear water and replace in the product.
17:36 Page 10

USE OF THE APPLIANCE

USE OF THE APPLIANCE

CLEANING AND MAINTENANCE

CLEANING AND MAINTENANCE
10