Technical Data; Electrical Diagram - ALPATEC MG 6 Mode D'emploi

All manuals and user guides at all-guides.com
notice MG6: notice MG1

TECHNICAL DATA

Capacity
Power
Voltage
Gaz
Contain gas with fluorinated greenhouse effect that depends on the protocol of KYOTO.
Hermetically sealed.

ELECTRICAL DIAGRAM

Note: stop the ice maker for 1h after 5 h working then start again if needed.
Lay the machine on the horizontal line for 5hours before you first use it. Clean the machine before you
first use it or if you did not use it for a long time (how to clean it, see page 10).
To ensure good ventilation, leave a gap of 20cm around the product.
Plug the ice maker
Open the front door (2). If it is the first time you use the ice maker, take the ice
spoon (8) out.
Fill water tank (4) with clean water, not exceeding 2,3 l.
Use button Mode (11) to choose the ice cube size. Each time you press the button,
the size change according to the following: small -> medium -> large -> small. Size
can be adjusted any time.
Press button M / A (10). Production will start soon after.
The time for ice making is 7 minutes for small cubes, 9 for medium and 11 for large.
First rounds may be longer and with different ice cube size because the compressor need to warm up.
The size of the ice cubes is related to the room temperature, which is why we ask you to conform to the
following table:
27/01/10 14:40 Page 9
15 to 18 kg of ice cube / day
160 W
230 V
R 134 a 0,065 Kg
USING
USING
9