ALPATEC MG 6 Mode D'emploi page 11

All manuals and user guides at all-guides.com
notice MG6: notice MG1
IF YOU DISCOVER THAT YOUR APPLIANCE HAS UNUSUAL SYMPTOMS PLEASE CHECK THE
FOLLOWING FIRST :
PROBLÈMES
There is a thundering noise
Lack of water (h) indicator is
activated but water level is right
Failure (i) indicator is activated
Compressor works but no ice is
produced
Ice cannot be pulled off
Ice maker stops during ice mak-
ing process
Bips can be heard and lack of
water (h) indicator is activated
Ice tank full (g) indicator is
activated
27/01/10 14:40 Page 11
TROUBLESHOOTING
TROUBLESHOOTING
CAUSES POSSIBLES
The voltage is lower than the
required one
Water pump is damaged
There is remaining ice in ice
making chamber (6)
There is stucked cubes in ice
making chamber (6)
the shovel is shifted
Other
Refrigerant is leaked
Electromagnetic valve is leaked
Electromagnetic valve is damaged
Power cord is damaged
Temperature is too high
Water level is too low
Ice tank is full
11
SUGGESTIONS DE SOLUTIONS
Turn off the ice maker and restart when the
voltage is normal
Contact a qualified electrician
Remove the ice and start again the ice maker
Stop the ice maker and remove the stucked
cubes
Stop the ice maker, re-place the shovel and
start again the ice maker
Contact a qualified electrician
Contact a qualified electrician
Contact a qualified electrician
Contact a qualified electrician
Contact a qualified electrician
Stop ice maker and restart one hour later
Fill with clean drinking water
Remove ice cubes