Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Appearance.
1-2x lens
2-Desktop
3-Magnetic sensor
4-switch:
5-Oblique light
6-UV light
7-Transmitted light
5-Power switch
6-Remote 10х mouse
7-Lens backlight ON button
Figure 1
4 Installation and maintenance rules.
1. The device should be installed on even horizontal surface, away from water and dan-
gerous objects.
2. Don't put the device in the areas where it can be affected by direct sunlight, direction-
al bright light, extreme vibration, dust.
3 If the device was exposed to cold for an extensive period of time, it is necessary to
keep it at the room temperature for not less than 3 hours.
4 Attention! Do not press two or more buttons on control panel simultaneously to avoid
failure of the detector.
5 Switch off the detector when it is not used for a long time to economize lamp resource.
6 Attention! In case of non-stop operation of the device for more than 8 hours, it is rec-
ommended to make a break for an hour to avoid overheating of the detector body and
UV lamps. It is forbidden to use the device non-stop for more than 12 hours and leave
the detector switched on without operator. Overheating and UV lamp failure is possible
in case of wrong detector exploitation.
Remember! The producer is not responsible for possible consequences in case of wrong
exploitation of the device.
11
Publicité
Table des Matières
