Environmental Protection - BGS technic 3237 Mode D'emploi

COMPONENTS
1 Metal sheet guide
2 Knife
3 Air outlet, rotatable
4 Trigger
5 Speed regulator
6 Cap / Air inlet
OPERATION
1. Remove the sealing cap from the compressed air inlet (6).
2. Mount the compressed air nipple on the compressed air inlet.
3. Put a few drops of compressed air device oil into the device via the air inlet.
4. Make sure that the trigger lever (4) is in the non-depressed position.
5. Connect the device to the compressed air source hose.
6. Start the device by pushing trigger (4).
7. Position the metal sheet guide (1) to the metal sheet to be cut.
TROUBLESHOOTING
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching

ENVIRONMENTAL PROTECTION

Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and disposed
of in a manner which is compatible with the environment. Contact your local solid
waste authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
(Insufficient power)
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor matches
tool's air pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed