STERWINS 25EGT1-300.1 Notice De Montage, Utilisation Et Entretien page 25

• Use safety equipment. Always wear eye protection. Protective equipment such as FR
dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate
conditions will reduce personal injury.
EN
• Avoid any untimely start-up. Make sure the switch is in the off position before plugging
the tool into the mains and / or battery pack, picking it up or carrying it. Carrying tools
with your finger on the switch or plugging in tools with the switch in the on position can
cause accidents.
• Remove any adjusting key or wrench before turning the power tool on. A wrench or a
key left attached to a rotating part of the power tool may result in personal injury.
• Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
• Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in a hazardous
situation.
• Do not rush. Maintain proper posture and balance at all times. This allows better control
of the tool in unexpected situations.
• Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in
moving parts.
• If devices are provided for the connection of equipment for dust extraction and
collection, ensure that they are connected and correctly used. Using dust collectors can
reduce the risk of dust.
• Never operate the machine while people, especially children, or pets are nearby.
• Never to replace the non-metallic cutting means with metallic cutting means.
• You should only use extension cords for outdoor use, PVC ordinary duty with a cross
sectional area not less than 1.0mm for extension cord up to 15 meters and 2.5 mm for
2 2
extension over 15 meters but less than 40 meters.
• Not to connect a damaged cord to the supply or touch a damaged cord before it is
disconnected from the supply for the reason that damaged cords can lead to contact with
live parts;
• Keep extension cords away from moving hazardous parts to avoid damages to the cords
which can lead to contact with live parts.
• Before use check the supply and extension cord for signs of damage or aging. If the cord
becomes damaged during use, disconnect the cord from the supply immediately. DO NOT
TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY. Do not use the machine if the cord
is damaged or worn.
25