H+H ORIGINAL babyruf MBF 8020 Mode D'emploi page 18

All manuals and user guides at all-guides.com
4.2 INSERTION OF BAT TERY PACK
Insert the pre-charged battery pack in the groove provided, making a note of the polarity (+/-) (see
marking on case) (see illustration D). Now close the battery compartment cover in reverse order
until it audibly engages.
The battery pack is pre-charged and can therefore be used immediately. No prior charging
before launch is required.
4.3 CHARGING THE BAT TERY PACK
The charging time for a completely empty battery package and turned off unit is about 16 hours.
If the receiver is turned on during the charging process the charging time is doubled.
4.3.1 CHARGING THE TR ANSMIT TER
1. Connect the power supply unit to the thin plug on the 9-V-socket of the transmitter (see
illustration E and F).
2. As soon as the power supply unit is connected to the transmitter, charging automatically
begins.
4.3.2 CHARGING THE RECEIVER
1. Connect the power supply unit to the thick plug on the charger station socket (see illustration
G and H).
2. As soon as the power supply unit is connected to the charger station and the receiver is on the
charger station, charging automatically begins (see illustration I). The illuminated red LED on
the charger station will indicate this process to you.
3. You can leave the unit in the charging station after completed charging. The LED on the
charging station is not turned off after charging is completed!
Tip! Overcharging the battery packages is technically impossible.
5. INITIAL OPER ATION
1. Place the transmitter vertically to the person being monitored (e. g. your baby).
Please Note! For safety reasons and for optimum sound transmission we recommend that
you keep the transmitter at least 1 metre from the baby. Never place it in the baby's cot,
bed or playpen!
2. The device is switched on using the slide switch of the transmitter. The sensitivity control
switch can be used to set the sensitivity of the transmitter to meet your own individual requi-
rements.
3. Place the receiver vertically near to you in another room.
4. The device is switched on using the slide switch of the receiver.
5. Transmission begins automatically as soon as the transmitter is activated by a sound. As soon
as a sound is transmitted you will notice this not only acoustically but also visually on the LED
strip. The louder the sound received, the more diodes light up.
6. To check the function of the baby monitor before using it for the first time, place your trans-
mitter in the desired room and e. g. put a radio on at the desired volume.
7. Walk through your house with your receiver and set the desired volume on the volume regula-
tor.
15