Getting Started - Inficon TEK-Mate 705-202-G Serie Mode D'emploi

Getting Started

1. Install the batteries. See
2. Install the sensor. See
NOTE: Installation of the batteries and sensor is required before use.
3. Long press the power button to turn TEK-Mate On or Off.
4. Wait for TEK-Mate to warm up. All three indicators will illuminate and TEK-Mate
will alarm during warm up. When the HIGH indicator starts flashing and
TEK-Mate beeps about one beep per second, warm-up is complete.
5. To toggle between HIGH and LOW sensitivity modes, press the Power button.
HIGH sensitivity is the default setting.
The INFICON TEK-Mate Refrigerant Leak Detector provides similar responses to
all CFCs, HCFCs, HFCs, HFOs, and refrigerant blends (e.g. R-410A, R407c) as
well as SF6.
How to Install the Alkaline Batteries
1. Remove the battery cover by releasing the latch and sliding the cover down and
off the handle. You may need a screwdriver or similar tool to do this.
2. Install two "D" size alkaline batteries as shown in
3. Reinstall the battery cover by aligning it with the handle and sliding it up until
the latch engages.
NOTES:
 Low battery is indicated by the green POWER indicator flashing. TEK-Mate
may continue to operate for up to one hour.
 Dead battery is indicated by the POWER and HIGH indicators flashing.
Figure 1. Properly Installed Alkaline Batteries
- +
+
How to Install the Alkaline
How to Install or Change the
-
4
Batteries.
Sensor.
Figure 1.