Publicité
Les langues disponibles
Les langues disponibles
Limiter Switch
2
To prevent hard clipping of the power amp, a selectable peak limiter is provided.
Gain Control
3
The Traynor Big Block's Gain control allows you to set the level of the signal before it's sent
to the tone controls. This allows control of the tonal 'sensitivity' or 'definition' of the amplifier.
Higher gain settings will give more 'growl' to your bass.
Tone Controls
4
A wide range of sonic possibilities, covering the entire audio spectrum, can be achieved
using the four active tone controls on the Big Block amplifier. Each tone control has a range
of ±15 db. The center position denotes a neutral or nominal setting for all controls. The Bass
control adjusts the level of the low frequency and works with the Low Mid, the next frequency
range up helping to scupt your bottom end. The Hi Mid covers the next higher frequency
range and the Treble control adjusts the upper frequency range.
2
1
3
10
11
10
0dB/Passive and -6dB/Active Inputs and Clip LED
1
Selectable Limiter
2
Gain Control
3
Tone Controls
4
Low Expander Control
5
Master Volume Control
6
Mute Switch
7
Tuner Out
8
Phones Jack
9
Power/Status LED (front panel), Switch and Receptacle (rear panel)
10
Circuit Brreaker
11
EFX Send & EFX Return Jacks
12
DI Line Out, EQ Pre/Post Switch & GND Lift Switch
13
External Speaker Output Jack
14
Tweeter In/Out Switch
15
7
4
5
6
12
13
2
10
8
9
14
15
Publicité
