Parts List - ITC SPT325 Manuel De L'utilisateur

Please refer to the schematic drawing on page 11.
No. Description
1 Screw
2 Spring washer
3 3/8" Chuck
4 Motor housing
5 Gear housing
6 Ball bearing
7 Pin
8 Gear
9 Shaft
10 Gear
11 Gear shaft
12 Ball bearing
13 Gear
14 Ball bearing
15 Gear housing
16 Motor housing cover
17 Brush holder cover
MAINTENANCE
n Keep the vents clear of dust and debris. This will help prevent possible
electrical shorts and ensure proper cooling.
n Keep the tool housing clean, free of oil and grease by using mild soap and
a damp (not wet) cloth.
n Inspect the cord regularly and have it replaced by an authorized repair
facility if it is damaged.
n Lubrication for this tool is done at the factory and should not be necessary
again under normal use.
n An authorized repair centre should do any repairs, modification, or
maintenance that involve disassembling the tool.
n Any damage to the tool should be corrected at an authorized repair centre.

PARTS LIST

WARRANTY
ITC branded power tools, air nailers staplers and compressors are designed for
use in DIY (do-it-yourself), light or intermittent duty, semi-professional applications.
They are not intended for use in professional, production, industrial or continual
use applications.
ITC makes every effort to ensure that its products meet high quality and durability
standards and are warranted for two years against manufacturers' faults and
defects for a period of two years from the date of purchase to the original owner.
ITC will REPAIR OR REPLACE (at our discretion) merchandise deemed by the
company to be defective, provided that it is has not been misused, abused, altered,
or repaired by anyone other than an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine
those products that are covered by our over-the counter warranty. Any ITC tool
that fails during normal use and within the specified warranty period and qualifies
for over-the counter warranty must be returned to its point of purchase for
replacement or credit. Any item not listed as over-the-counter warranty must be
shipped, prepaid freight, to an authorized repair depot accompanied by a copy of
the invoice specifying the date that the item was purchased. Returned tools that
are not accompanied by a proof of purchase (Copy of Invoice) will not be repaired
or replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad
and staple gun driver blades, grinding discs, saw blades, driver bits, electric motor
brushes, worn chords, etc. It also does not apply to ITC tools used in professional,
production, industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.
No. Description
18 Carbon brush
19 Brush holder
20 Gear shaft
21 Ball bearing
22 Armature
23 Ball bearing
24 Armature
25 Ball bearing
26 Field
27 Screw
28 Switch
29 Cord
30 Screw
31 Inductor "A"
32 Inductor "B"
33 Capacitor
5
v.081125