Remove The Battery Pack; Parts List - ITC SCT512 Mode D'emploi

MAINTENANCE
= Keep the tool clean using a soft damp (not wet) cloth. Do not use solvents on the plastic parts.
= Lubrication is not necessary. After long use, have an authorized service centre maintain and lubricate the tool.
= Should the chuck require replacement:

1. Remove the battery pack

2. Open the chuck jaws as widely as possible so you can get at the chuck retaining screw.
3. Unscrew the chuck retaining screw with a phillps screwdriver.
NOTE: This is a left hand threaded screw and you remove it by turning it clockwise.
4. Shift the speed selector to low gear (slide it to the back so the of number 1 is visible).
5. Clamp the shorter arm of a large allen wrench in the chuck, aligning it with the jaws so they grip three of its six
flat sides.
6. Place the drill on a flat surface, and support the chuck with a piece wood about 8 mm or 3/8" above that surface.
7. Strike the long arm of the wrench with a hammer so that the chuck turns counter-clockwise and unscrews from
the spindle. This may require a fairly sharp blow.
8. Repeat the process in reverse to install a new chuck.
WARNING! Repairs should be made by an authorized repair centre. Opening
this tool could invalidate your warranty.

PARTS LIST

N DESCRIPTION
O.
PWX-SCT512-1 Chuck
PWX-SCT512 2 Compression plate
PWX-SCT512 3 Torque setting ring
PWX-SCT512 4 Heat sink
PWX-SCT512 5 Orientation block (up)
PWX-SCT512 6 Orientation block (down)
PWX-SCT512 7 Forward/Reverse/Lock button
PWX-SCT512 8 Shaft guide
PWX-SCT512 9 Spring
PWX-SCT512 10 Trigger switch
PWX-SCT512 11 Spacer
PWX-SCT512 12 Ball bearing
PWX-SCT512 13 Battery clip
PWX-SCT512 14 Gear box (front)
PWX-SCT512 15 Left casing
PWX-SCT512 16 Gear box (rear)
PWX-SCT512 17 Steel adaptor
PWX-SCT512 18 Connection clip
PWX-SCT512 19 Screw
PWX-SCT512 20 Motor gear
6
Please see Schematic Drawing, on page 13
!
N DESCRIPTION
O.
PWX-SCT512 21 D.C. motor
PWX-SCT512 22 Right casing
PWX-SCT512 23 Accessory clip
PWX-SCT512 24 Charger
PWX-SCT512 25 Battery pack upper casing
PWX-SCT512 26 Contact
PWX-SCT512 27 S-type spacer
PWX-SCT512 28 Battery lock / release tab
PWX-SCT512 29 Battery
PWX-SCT512 30 Battery pack lower casing
PWX-SCT512 31 Screw
PWX-SCT512 32 Elastic clip
PWX-SCT512 33 Gear selector
PWX-SCT512 34 Bubble vial
PWX-SCT512 35 Handle cover
PWX-SCT512 36 Chuck retaining screw
PWX-SCT512 37 Screw
PWX-SCT512 38 Shaft
PWX-SCT512 39 Screw
PWX-SCT512 40 Screw