Maintenance; Clean The Dustbin; Clean The Sensor - GreenWorks GRV-3011 Manuel D'opérateur

EN
Remote cleaning mode (It is only supported with the
mobile App)
• The manual remote control mode can be used in the APP
to control the vacuum cleaner to get to the area that needs
to be cleaned.
Zone cleaning mode (It is only supported with the mobile
App)
Use the mobile APP to set the zone cleaning, and the robotic
vacuum cleaner will clean one or more rooms checked on the
APP zoning map.
• After starting to clean, the vacuum cleaner may enter the
zone outside the selected zone, clear floor obstacles
around the selected zone. The zone selection cannot
ensure safe isolation;
• Zone cleaning can be started only after the vacuum
cleaner successfully creates a map.
Selected zone cleaning mode (It is only supported with the
mobile App)
Select the zone cleaning mode in the APP and set a cleaning
area. The vacuum cleaner will only clean this zone and return
to the charging dock after cleaning.
• Zone cleaning can be started only after the vacuum
cleaner successfully creates a map.
7

MAINTENANCE

7.1

CLEAN THE DUSTBIN

1. Empty the dust box. Put the dust box close to the trash
can, and tap the dust box gently to knock off excess dirt.
2. Take out the high-performance filter and clean the filter
with the supplied cleaning brush.
English
3. If necessary, rinse the dust box and filter assembly
thoroughly with water. (Note: The filter cannot be
cleaned with hot water or detergent.)
4. After rinsing, the dust box and filter assembly must be
thoroughly air-dried. (Note: Repeated rinsing will destroy
the high-performance filter material and make it
ineffective. Please clean it carefully.)
5. Reassemble the dust box, and filter assembly, and put
them back into the vacuum cleaner.
7.2

CLEAN THE SENSOR

Please clean the sensor regularly, and wipe off the dust on the
sensor with a soft dry cloth or cleaning brush.
14