Lupus Electronics LUPUSNET - LE900 Manuel De L'utilisateur page 69

i
MXR Client Software only can be installed and run on the PC that is using independent
-
graphic card.
The DVR server does not support the remote setup through the Internet (WAN) for the
-
first time setup. Please have your PC and the DVR server at same LAN segment
(network).
VII. Connect a DVR Server for Monitoring
17. The default IP of the DVR server is 192.168.2.2 for LAN1 (lower LAN port in the back of the
DVR) or 192.168.3.2 for LAN2 (upper LAN port in the back of the DVR).
i
The port LAN 1 that is located at lower position is only configurable for Fixed IP of
-
the network mode.
Port LAN2 is configurable for PPPOE, DHCP, or Fixed IP of the network mode.
-
Please make sure DVR server and your PC is connected in the same physical network
in order for search function can work correctly.
18. Run the MXR Client Software on your PC. To run the application, click
desktop or click Start > Programs > DVR > DVR Server > MXR.
19. Enter the ID and Password(default is superuser/111111) to login the MXR Client
application.
20. Click (Setup) from MXR Client application interface. Enter the ID and Password
(default is superuser/111111). And then, select Client Setup mode. The System Setting
window will show up.
21. Click Add, and then, click Search to find the DVR server that you have installed on your
network.
22. Select the DVR server that you want to configure from the search result list and click OK.
69
on your PC