Makita BTP130 Manuel D'instruction page 7

1
007162
Before operation, always make sure that the lever is
correctly set to your desired mode mark and use the tool
at an appropriate speed for your work.
CAUTION:
When using the action mode change lever, use only
•
when the tool stops. But when the lever does not
easily move, pull the switch trigger slightly to rotate
the spindle and then move the lever.
Always set the lever correctly to your desired mode
•
mark. If you operate the tool with the lever
positioned halfway between the mode marks, the
tool may be damaged.
Adjusting the fastening torque (Only for
screwdriving operation mode "
3
007163
The fastening torque can be adjusted in 16 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body. The fastening
torque is minimum when the number 1 is aligned with the
pointer, and maximum when the number 16 is aligned
with the pointer.
The clutch will slip at various torque levels when set at
the number 1 to 16.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
NOTE:
In modes other than screwdriving mode, the
•
adjusting ring can be placed at any position
because it does not work.
All manuals and user guides at all-guides.com
1. Action mode
changing lever
")
1. Adjusting ring
2. Graduation
1
3. Pointer
2
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
For tool with shallow bit hole
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
To install these types of bits, follow
A=17mm
the procedure (1).
B=14mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
006349
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
1 2
001267
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
7
1. Bit
2. Sleeve