Foppapedretti ISOPLUS Instructions De Montage page 28

• ENGLISH •
All manuals and user guides at all-guides.com
INSTALLING THE CAR SEAT
REMOVING THE HARNESS - See figure "3a, 3b, 3c, 3d"
Completely loosen the shoulder straps, see paragraph "loosening the harness" (Group 1).
Pull the handle on the headrest and, keeping it pulled, raise or lower the headrest,
adjusting it according to the child's height.
Press the red button on the central buckle to release the shoulder straps.
Unhook the press studs on the sides of the backrest fabric, place the shoulder straps on
the back of the fabric. Place the buckle tips on the seat sides, in the lower part (fig 3b).
Position the backrest fabric correctly and attach the press studs.
Remove the buckle protection padding and store it in a safe place or place it behind the
backrest fabric, with the chest straps.
Lift up the seat cover fabric, pulling it out of the harness adjustment device and lift up
the inner padding, pulling it out of the harness adjustment device, pulling carefully
and gently.
Unthread the buckle inwards from the slots in the fabric and padding, open up the
container compartment door and put the buckle back inside. Close the compartment.
Reposition the internal padding correctly on the seat.
Reposition the seat lining correctly, fitting the fabric around the harness adjustment
device.
Reposition the lining correctly along the outer edge of the car seat.
Group 2 and 3 use (from 15 to 36 kg)
Place the car seat on the vehicle's passenger seat in a forward-facing position.
Pass the diagonal part of the 3-point seat belt behind the headrest of the car seat and
through the red diagonal belt guide (A) 3e located on the lower part of the headrest,
on the retractor side.
Place your child in the car seat.
Attach the 3-point belt to the vehicle's buckle and pass the lap belt through the red
"lap belt guides" (15), making sure that the lower end of the diagonal belt also passes
through the lap belt guide on the buckle side.
Pull the diagonal part of the belt towards the retractor so that the belt is taut and
adheres to the chest and legs of the child. See figure "3e".
Make sure that it is installed correctly.
28