• ENGLISH •
All manuals and user guides at all-guides.com
INSTALLING THE CAR SEAT
SECURING THE CHILD IN THE CAR SEAT
The ISOPLUS car seat can be used with the following weight groups:
group 1 (from 9 to 18 kg) - the 5-point harness supplied with the car seat is used.
group 2-3 (from 15 to 36 kg) - the harness supplied with the car seat is removed and
the vehicle's 3-point seat belt is used.
Group 1 (from 9 to 18 kg) - HARNESS - See figure "2a, 2b"
Loosening the harness: press the adjustment button A and at the same time grasp the
straps (chest belts) in the lower part, below the chest protector padding, and pull them
forwards to loosen them.
IMPORTANT: Do not pull on the straps by gripping the chest protector padding.
Press the red button on the central buckle to unclip the straps and place them to the
side of the car seat; you can secure the ends of the buckle with the elastic loops located
on the sides of the seat.
Place the child in the car seat. Slide the straps over the child's shoulders and bring
together the two ends/tabs of the straps to make a single connector.
Insert the connector into the central buckle until you hear a "click".
Tightening the harness: Pull the harness adjustment strap so as to tighten it properly
against the body of the child. The harness is correctly tightened when the gap between
the harness and the child is no greater than the thickness of your finger (1 cm).
NOTE: check that the buckle is secured by tugging the shoulder and waist straps.
CONVERTING FOR GROUPS 2-3 (15-36kg)
It is recommended that you use the 5-point harness for as long as possible.
If you remove the booster cushion this could allow you to use the seat in group l
configuration for longer.
When your child has outgrown the group 1 (9-18kg) configuration and you wish to use
the seat for a child in either group 2 (15 - 25kg) or group 3 (22-36kg) then you will need
to remove the child car seats integral 5-point harness.
27