Description
The Greenlee GT-65 and GT-95 Voltage and Continuity Testers are intended
to measure voltage and verify continuity. Each model has LEDs to indicate
common voltages. They also have non-contact and single-probe voltage
detection capability.
In addition, the GT-95 has an easy-to-read LCD and a shaker to signal AC
voltage measurement. This model can trip a ground-fault circuit interrupter
(GFCI). The LEDs glow green at low voltage, and change to red when the
measured voltage presents a shock hazard.
Both models have an indicator self-test feature that allows the user to verify
the functionality of the voltage-indicating LEDs, the continuity beeper, and
the GT-95 LCD.
Safety
Safety is essential in the use and maintenance of Greenlee tools and
equipment. This instruction manual and any markings on the tool provide
information for avoiding hazards and unsafe practices related to the use of
this tool. Observe all of the safety information provided.
Purpose of This Manual
This instruction manual is intended to familiarize all personnel with the safe
operation and maintenance procedures for the Greenlee GT-65 and GT-95
Voltage and Continuity Testers.
Keep this manual available to all personnel. Replacement manuals are
available upon request at no charge.
All specifications are nominal and may change as design improvements occur.
Greenlee Textron Inc. shall not be liable for damages resulting from misapplication or
misuse of its products.
® Registered: The color green for electrical test instruments is a registered trademark
of Greenlee Textron Inc.
KEEP THIS MANUAL
2
1.800.561.8187
information@itm.com
www.
.com