Jackery Explorer 2000 Pro Manuel D'utilisation page 5

LED Light On/Off
There are three modes of LED Light: Low Light mode, Bright Light mode, and SOS mode.
The operations are as follows: Press the LED Light Button, the LED will be turned on. The light will
always turn on in Low Light mode and the output power on the screen is 1W. Press again to enter the
Bright Light mode and the output power on the screen is 3W. Press the third time to enter the SOS
mode and the output power on the screen is 3W. Then, press again to turn off the LED Light. In any
of these modes, the light can be turned off by a long press.
Charging Your Jackery Explorer 2000 Pro
Green energy first: We advocate to use the green energy first. This product supports two modes of
charging at the same time: solar charging and AC wall charging.
When AC wall charging and solar charging are turned on at the same time, the product will give
priority to solar charging and both methods will be used to charge the battery at the maximum
permissible power.
Charging from the wall
Please use the AC cable included in the package.
AC Charger
Explorer 2000 Pro
7
EN EN
Charging from Solar
Solar Generator Connector (Tip: This accessory is sold separately)
Two or three solar panels can be connected in series through this adapter. To ensure that the solar
panels can exert the maximum power output, please make sure to use the same type of solar panels
when connected in series.
Functions of Main Ports
The solar panel charging input port (DC8020 female)
❶ The solar panel charging output port (DC8020 male): When charging, plug this port into the DC input
port of the Jackery Explorer 2000 Pro.
❷ The solar panel charging input port (DC8020 female): When charging, connect solar panel(s) to this port.
❸ The change-over switch for changing from two to three solar panels in series: When connecting two
solar panels to charge, the switch should be kept OFF, otherwise it cannot be charged. If the switch
is ON, three solar panels need to be connected at the same time to use it.
How to Use (Take 200W Solar Panel As An Example)
Jackery SolarSaga solar panels (68W, 100W and 200W) are equipped with 2 port types at the output
interface. Please refer to the following illustrations to connect the solar panel and the adapter.
When connecting two 200W solar panels, please operate as follows:
DC8020
SolarSaga 200
DC7909
The solar panel charging output port (DC8020 male)
The change-over switch for changing from two to three solar panels in series
SolarSaga 200×2
8
Explorer 2000 Pro