AquaScape Waterfall Spillway 22 Instructions Et Entretien page 4

• Remove the outer rubber gasket from the Waterfall
Spillway fitting. Insert the hole in the liner over the Waterfall
Spillway fitting. The liner should fit snug around the base of
the Waterfall Spillway fitting (Ex. 9).
• Place the second rubber gasket onto the fitting (Ex. 10).
NOTE: The liner should be located between both rubber
gaskets.
• Place retaining nut on
Waterfall Spillway and hand
tighten. The fitting is reverse
threaded, please refer to
the arrow located on the
retaining nut for proper
direction. Use a pair channel
locks to further tighten
down the retaining nut and additional 1/4 to 1/2 turn past
hand tight being careful to not over tighten retaining nut,
which could possibly crack the plastic fitting (Ex. 11).
STEP 4
CONNECT THE PIPE
• Install the included pipe
fitting into the back of the
Waterfall Spillway. Use
Teflon tape or silicone
sealant (not included) on
the threads of the fitting,
in order to provide a water
tight seal. Be careful to not
over tighten pipe fitting, which could possibly crack the
plastic fittings. The filter is now ready for the pipe to be
installed (Ex. 12).
STEP 5
FILL JOINTS WITH BLACK WATERFALL FOAM
• The joints around the face
of the Waterfall Spillway
and surrounding waterfall
stones can now be filled
with Aquascape Pond and
Waterfall Foam Sealant
(Ex. 13).
NOTE: The waterfall can be operated once the foam is dry.
4
Inner rubber
gasket
Liner
Outer rubber gasket
Ex. 9
STEP 6
DISGUISE THE WATERFALL SPILLWAY
• Disguise the Waterfall
Spillway using boulders,
logs, gravel, soil, or other
creative landscape materials
(Ex. 14).
STEP 7
Retaining nut
TRIM EXCESS LINER
Ex. 10
• With the waterfall running, trim off any excess liner leaving
several inches above the water level/water splash as a
precaution. The remaining liner edges can be covered with
gravel or other suitable landscape material.
Ex. 11
Ex. 12
Ex. 13
US (866) 877-6637 |
☎
CAN (866) 766-3426 | aquascapeinc.com
☎
Ex. 14