AquaScape Waterfall Spillway 22 Instructions Et Entretien page 3

Contents
No. Description
1. Waterfall Spillway
2. 2" MPT x Slip
3. Multi-Hose Adapter 2"MPT x 1.5", 2" Barbed
Installation
STEP 1
BUILD WATERFALL AND STREAM
• Build waterfall and stream, providing enough liner at the
top of the waterfall to wrap over the top of the Waterfall
Spillway.
STEP 2
PLACE WATERFALL SPILLWAY
• Set the Waterfall Spillway into the desired location
(Ex. 1). Ensure the top of the spillway is facing upward
(Ex. 2).
Ex. 1
• Adjust the height of the Waterfall Spillway to match the
starting point of the waterfall. A bed of gravel can be
placed on top of the liner, beneath the Waterfall Spillway,
to raise the height of the spillway to the desired level
(Ex. 3).
• Level the spillway from side-to-side and tilted forward a
1/4" bubble on a 2 foot level (Ex. 4).
Ex. 3
aquascapeinc.com | CAN (866) 766-3426 |
☎
1
Top
Flat Bottom
Ex. 2
Ex. 4
☎ US (866) 877-6637
STEP 3
CONNECT TO LINER
• Fold the liner over the top of the Waterfall Spillway. It
is recommended to provide some slack in the liner in
case the position of the Waterfall Spillway needs minor
adjustment during installation (Ex. 5).
• Using a screw driver or awl, puncture a small hole in the
liner through the center of the Waterfall Spillway fitting
(Ex. 6). This will be your reference point for the location of
the liner connection.
Ex. 5
• Unfold the liner back off the Waterfall Spillway and remove
the retaining nut from the Waterfall Spillway fitting. Center
the retaining nut over the puncture hole in the liner. Use a
pen marker, awl, or screwdriver to trace a line around the
inside of the nut (Ex. 7).
• Remove the retaining nut and trim a hole in the liner
approximately 1/8" inside of the score mark (Ex. 8).
Ex. 7
2
3
Ex. 6
Ex. 8
3