Publicité
Base Mounting Hardware (x2)
The Telos Multi-Rack Adapter can be used with or without existing carriers.
For bare cross-bars or saddle styled carriers: Complete Assembly Needed.
Begin by removing all components from the box and assemble the loading ramp to the base with the
provided hardware.
1. Place the loading ramp over the end tubes of the base and secure with the carriage bolt, down
from the top and through the mounting bracket as shown.
2. Next, insert a mounting bolt into one mounting hole of the base, from the top side, and down
through one hole of a Jawz
3. Place the Multi-Rack Adapter onto the outer edge of a cross bar with the boarding ramp facing out.
4. Insert a second mounting bolt into the unused top hole and down
through the Jawz
tm
tighten until the Multi-Rack Adapter is secure. Repeat steps 1-4
to install the second Multi-Rack Adapter.
5. With the Multi-Rack Adapters securely in place refer to your
Telos
instructions and follow the loading procedure as
tm
described.
MALONE
Base (x2)
NOTE: Cross bars must be installed on vehicle.
mounting adapter and loosely apply a round hand knob.
tm
adapter. Apply a second hand knob and
Loading Ramp (x2)
Loading Ramp
Mounting Harware(x2)
PARTS LIST
PARTS LIST
R
Publicité
