Publicité
With existing J-style carriers: Only Loading Ramp Needed.
Begin by removing all components from the box.
1. Place the loading ramp over the end tubes of the existing carrier. Secure with the carriage bolt,
down from the top and through the mounting bracket as shown.
*Note: Carriers foam may need adjusting to accommodate the loading ramp. Adjust as needed. All
photos are for reference only.
Repeat to install the second Multi-Rack Adapter.
With the Multi-Rack Adapters securely in place refer to your Telos
loading procedure as described.
*Note: If your cross bars extending past the loading ramp prevent the Telos
functioning properly, the complete assembly can be installed and used as pictured below.
With the Multi-Rack Adapters securely in place refer to your Telos
loading procedure as described.
NOTE: The Malone Multi-Rack Adapter is a load assist module only and should not be used as a
load bearing or tie off point for your kayak(s). Follow your carriers instructions for safe
strapping and transport procedure.
instructions and follow the
tm
from attaching and
tm
instructions and follow the
tm
Publicité
