RIDGID RD80701 Manuel D'utilisation page 12

ASSEMBLY
wARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Failure to
heed this warning could result in serious personal
injury.
wARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
wARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
ATTAChING ThE FRONT SUPPORT
See Figure 2.
 Lift the machine and slide the front support into the front
tubes.
 Push the screw into the holes in the front tubes. Tighten
securely using the hex nuts.
ATTAChING ThE whEEL ASSEMBLY
See Figure 2.
 Locate the axle, hitch pins, washer, and wheels. Remove
the hitch pin from the axle.
 Slide the axle through the hole in the center of the
wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mounting
hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
ATTAChING ThE TRIGGER hANDLE REST
See Figure 3.
 Locate the trigger handle rest (front and back), screws,
and lock nut.
 Push the screws into the holes. Tighten securely using
the lock nut.
All manuals and user guides at all-guides.com
8 — English
CAUTION:
Failure to remove pump oil plug label may result in
decreased pump life.
REMOvE ThE LABEL
See Figure 4.
Remove pump oil cap label from the oil pump.
RAISING AND LOwERING ThE hANDLE
See Figure 4.
 To raise the handle: pull the handle up until the handle
knob snaps through the locking hole to secure the handle
in place.
 To lower the handle: pull the handle knob out then lower
the handle to the position shown in figure 4.
wARNING:
Make sure the nozzle and hose connections are
secure before starting the machine. A non-secured
accessory could become a projectile if not properly
installed which could result in serious injury.
ASSEMBLING ThE TRIGGER hANDLE
See Figure 5.
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 Turn the connector clockwise until it stops. This
the wand in place.
 When not in use, remove the spray wand from the trigger
handle by turning the connector counterclockwise.
the unassembled spray wand in the spray wand
area.
ATTAChING ThE AUXILIARY hANDLE
See Figure 5.
 Place the threaded stud on the end of the auxiliary handle
into the hole in the trigger handle as shown below. Turn
clockwise to tighten.
NOTE: You can install the handle on either the left or
right side of the spray wand, depending on operator
preference. The handle must always be used to prevent
loss of control and possible serious injury.
 To switch sides, loosen the auxiliary handle and rotate to
the opposite side. Tighten securely before use.
secures
Store
storage