DJ-Tech i-Mix MKII Manuel D'utilisation page 6

OPERATIONS
1. Install the DJ software from the software CD included.
2. Install the ASIO driver for i-Mix MKII from the Software CD "Drivers" folder. (ASIO Driver also available
on http://www.djtechpro.com)
3. You may need to power on/ off the i-Mix MKII when installing the driver.
4. Open the DJ software.
5. Start up the software to perform settings with the i-Mix MKII.
The software may not recognize the i-Mix MKII if it is connected to the computer after the software
has started.
6. Operations after the system recovering from power saving mode is not guaranteed.
Please power off and on again the unit when the system is recovered from power saving mode.
7. I-Mix MKII can be used with many other DJ software products that have a MIDI LEARN function. The i-Mix
MKII can control all software that has this function. i-Mix MKII can be used to control parameters of the
software. Please visit http://www.djtechpro.com for supported DJ software like Traktor Pro. Some mapping
files are also available there.
The MIDI LEARN setting for any software is different; please refer to any software's manual for
further instructions.
AUDIO I/O CONFIGURATION
Block Diagram for the USB Audio Configuration
REAR PANEL
Audio Out 1
Mic In
1. The audio interface of the unit is only an USB Audio Soundcard, while the faders and knobs controls
are for MIDI only. The unit cannot work as a mixer without the use of computer software.
2. Audio of Output 1 and Output 2 at the rear panel are the same, they are from USB Audio Output 1
plus the Microphone signal.
All manuals and user guides at all-guides.com
USB
Audio In 2
2-in 2-out
Audio In 1
USB Audio
Soundcard
Audio Out 2
∑
FRONT PANEL
5
Audio Output to Rear Panel
Volume Control