Dryer Description; The Features; Control Panel - Hotpoint Ariston FTCF 87B Instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Dryer Description

The features

Condenser cover

Control panel

The ON/OFF button
: If the dryer is running and this
button is pressed and held for more that 3 seconds the dryer
is turned off, it counts down 3, 2, 1, Off and the programme
is then cancelled.
Press and hold for more than 3 seconds and the dryer
reactivates.
The PROGRAMMES knob sets the programme: rotate it until
the indicator is pointing to the programme you want to select
(see Start and Programmes).
The OPTION buttons select available options for your
selected programme. The lights indicate that the option has
been selected (see Start and Programmes).
The START/PAUSE button/light
programme. When you press this button there will be one
beep and the progress lights will flash to confirm the action.
When a programme is running, pressing this button in pauses
the programme and stops the dryer.
The light is green when programme is running, flashing amber
if the programme has been paused or flashing green if on
standby waiting to start a programme (see Start and
Programmes).
The Display Unit gives an indication of the drying or delay
time together with icons that light to give warning information
and show the status of your programmes progress.
Rating plate
Filter
Indicator
PROGRAMME
knob
ON/OFF
Button
starts a selected
Water container
Model & Serial numbers
Air intake grille
Key Lock
Button & Light
Display Unit &
Selection Buttons
OPTION
Buttons & Lights
The three buttons below the display select 'Automatic' or
'Timed Dry' and if required a delayed start (see Start and
Programmes or The Display).
The Key Lock button/light
button after selecting your programme and any options, the
light turns on. This prevents the programme settings from
being changed. When the light is lit, the other buttons are
disabled. Hold the button to cancel and the light will go out.
The Empty Water icon
should be emptied. The display will take a few seconds to
update after replacing the empty water container, the dryer
must be running for this to happen (see The Controls).
Note: If the water container fills the 'water container full 'icon
flashes, the display shows
your clothes will not dry.
The Clean Filter icon
: gives a reminder before every
programme, that it is essential to clean the filter every time
the dryer is used (see Maintenance and Care).
The Clean Condenser icon
essential to clean the condenser at regular intervals (see
Maintenance and Care).
Condenser cover handle
(Pull to open)
HEAT LEVEL
Button & Lights
START/PAUSE
Button & Light
: Press and hold this
: signals that the water container
, the heat is turned off and
: gives a reminder that it is
GB
7

Publicité

Table des Matières
loading

Table des Matières