Cargo vedpak 178 Manuel D'installation page 5

WIRING & FUNCTIONS
Different applications require different functions. It is highly recommended to determine and configure the
required functions prior to Installation; (refer to 'CONTROL CABLE' section).
NOTE: Middle Section lights are independently switched and do not form part of the R65 Approval
POWER WIRES
1. Route Power Cable to the vehicle firewall towards the battery.
2. Follow factory wiring harness through the firewall. It may be necessary to drill a hole in the firewall.
Ensure that there are no components that could be damaged from the drilling.
3. Route the cable to the battery.
4. Install a 15Amp fuse (user-supplied) on the end of RED wire, then connect to battery.
5. Connect BLACK wire to the factory chassis ground adjacent to the battery.
NOTE: Make sure that all wires of power cable are securely connected to power source.
LIGHTBAR WIRING
RED To +VDC
BLACK To chassis ground
Flash pattern and DIM Mode
YELLOW
WHITE Warning Mode
Functions are activated by applying +VDC to a control wire.
5
171849
to +VDC
to chassis ground
Flash pattern and DIM Mode
Warning Mode
Vedpak 178_Version 2_061013