SPORTSTECH Speedbike SX400 Mode D'emploi page 30

Slide the handlebar post (pt.17) into
the handlebar post housing on the main
frame (pt.16). You will have to slacken
the knurled section of the L-shaped
knob (pt.26) and pull the knob back
and then select the desired height.
Release the knob and retighten the
knurled portion.
Then fix the handlebar (pt.18) with a
flat washer 1 (20) and L-shaped knob
(19)
ATTENTION: YOU SHOULD FIX THE
HANDLEBAR TIGHTLY!
Fix the computer (pt.78) onto the
computer holder with a bolt (pt.55) and
connect the plug (A1&A2).
The pedals (pt.1 L & pt.1 R) are
marked „L" and „R" - Left and Right.
Connect them to their appropriate
crank arms. The right crank arm is on
the right-hand side of the cycle as you
sit on it. Note that the right pedal should
be threaded on clockwise and the left
pedal counter-clockwise.
Firmly tighten all component parts and pre-assembled parts!
Re-check the tightness before each training session!
30