Nicols GP 200 Z IP Manuel D'utilisation page 15

User manual GP 200 Z IP
GOBOS WHEEL
The GP 200 Z IP is equipped with a rotating gobo
wheel comprising 7 locations, 1 of which is empty.
Gobos are replaceable with custom gobos.
To replace a gobo, please follow the procedure:
Warning: for the replacement of the gobos, please
put your GP 200 Z IP in a heated room (in order to
avoid any condensation inside the device)
After unplugging your GP 200 Z IP, to change a gobo,
open the access hatch under the device (10cm x
5cm, 4 countersunk screws with a central safety
valve)
Turn the wheel pictured by hand until you have the
gobo you want to replace in front of us. (do not insert
a gobo in the original empty slot in position 0)
The gobo is embedded in the big wheel, and held by
a spring in the center of the wheel.
Pinch the desired gobo gear with your fingernail
forefinger and thumb.
Tilt it forward towards the exit lens and pull it up out
of the device.
To insert your new logo, insert your gobo in the
central spring and push it into its location. The gobo
must be perfectly embedded in the retaining clips.
Check that the gobo turns perfectly and causes the
rotation of the other gobos, then check the rotation
of the wheel.
If you notice any friction or non-rotation of the
gobos, it means that the gobo you have just inserted
is not properly engaged, please repeat the procedure.
Remark :
In the event of misting inside the optical lens (exit of
the light beam). Place the appliance in a heated room
with the access hatch on top.
Open the access hatch and let the device run for 10
hours.
Close the access door, you can install the device
again.
15