Panasonic NC-ER22N Manuel D'utilisation page 23

208
10hrs
Economy
140
6 hrs Timer
Cleaning
Lights
Flashing Lights solidly Goes out
⇒
208
10hrs
Economy
140 6 hrs
Timer
Cleaning
208
10hrs
Economy
140 6 hrs
Timer
Cleaning
Flashing
All manuals and user guides at all-guides.com
How to Use
Economy timer
Select
When the unit will not be used for a short time, such as
when you are sleeping or when you go out for the day,
by setting this timer you can reduce the amount of
electricity used.
Select either the "6 hrs" or "10 hrs" timer, depending on how
●
long you will sleep or be away from your house.
Press the 'Select' key to select the "6 hrs" or "10 hrs" timer.
When the timer is started, the indicator light will light, and the
temperature of hot water will drop automatically (to approx.
140¡F (60¡C)).
6 or 10 hours later, the timer will be reset. After the water is
brought up to boiling temperature again, it will be kept warm at
approx. 208¡F (98¡C).
140 keep-warm function
Press the 'Select' key to select "140".
Select
(The '140' indicator light will flash.)
The temperature of hot water will drop to approx. 140¡F (60¡C).
(When the temperature reaches approx. 140¡F (60¡C), the
indicator light will change to steadily lit.)
Time required to reach approx. 140¡F (60¡C)
Approx. 3 - 4 hours
(Amount of water : Maximum, Room temperature: 68¡F (20¡C))
Precautions when the economy timer is used or
when the 140 keep-warm function is selected
When the power is restored after a power failure, the keep-
●
warm temperature will be set to "208".
When the temperature of hot water has dropped because
●
water was added, the water will be brought up to boiling
temperature.
The keep-warm temperature can be changed while the
●
water is being boiled.
The economy timer can be set while the water is being
●
boiled. In this case, even though the timer has been started,
the water will be brought to boiling temperature.
The minimum water temperature is approx. 140¡F (60¡C)
●
while the economy timer is being used.
Notice
Do not use the unit near an open flame.
●
(The unit may become deformed.)
Do not supply water directly from the tap.
●
(If the water overflows the pot and it enters the electrical parts
built into the main unit, it may cause a malfunction.)
Do not leave water standing in the container.
●
(It may cause the container to corrode or smell.)
Do not pour water out of the pot over the side where the
●
operation panel is located.
(Water infiltration may cause a malfunction.)
20