Electrolux ERF3867SOW Notice D'utilisation page 35

All manuals and user guides at all-guides.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
cold.
The temperature in
the appliance is too
warm.
The temperature in
the refrigeration is
too warm.
The appliance does
not operate.
Not enough carbon
dioxide in the water.
Too much carbon
dioxide in the water.
No carbon dioxide.
No or very low water
flow.
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The Temperature regulator
may be set incorrectly.
The Temperature regulator
may be set incorrectly.
The door is not closed
correctly.
The food temperature is
too high.
There is no cold air circu-
lation in the appliance.
Large quantities of food to
be cooled were put in at
the same time.
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The carbon dioxide is run-
ning out.
Dilute with ordinary water.
The gas cylinder is empty.
The gas cylinder is empty.
Sediment in the water.
Water supply obstructed.
ENGLISH
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a warmer temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the food temperature
decrease to room tempera-
ture before storage.
Make sure that there is cold
air circulation in the appli-
ance.
Insert smaller quantities of
food to be cooled at the
same time.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a another electrical
appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.
Refer to "Installation of the
gas cylinder".
Refer to "Selecting and dis-
pensing water".
Refer to "Replacing gas cyl-
inder"
Refer to "Replacing gas cyl-
inder".
Remove and clean the
strainer in the inlet hose
connection.
Check water supply.
35