GE RAK348T1 Instructions D'installation page 11

INSTALLATION INSTRUCTIONS
9. Clean the mounting location. Install the four mounting
post feet into each corner hole on the underside of the
receiver. Peel off the adhesive backing from each foot.
Locate and press the receiver onto the unit, in the correct
location, for either Models with a Junction Box or Models
without a Junction Box. See below illustration to determine
the correct location for your model type. (If accidentally
placed in the wrong location or if the receiver needs to
be moved, carefully pry each foot from the unit, apply
two-sided tape to the feet and relocate to the new
location.)
Models with a
Junction Box
Recommended mounting
location – Mount the
receiver to the side
of the Junction Box
NOTE: If replacement mounting feet are needed, they may be
ordered at www.mouser.com. Order part no. 561-LAD187.
10. Replace the access cover with the screw removed earlier.
11. Reinstall the room cabinet by hooking the top over the rail
along the unit top, then pushing it in at the bottom.
Models without
a Junction Box
OR
Recommended mounting
location – Mount the
receiver to the side of
the unit
11