Axis Communications P5544 Guide D'installation page 8

Page 8
Connectors
Network connector – RJ-45 Ethernet connector. Supports Power over Ethernet Plus (PoE+),
IEEE 802.3at). Use the supplied midspan.
Due to local regulations or the environmental and electrical conditions in which the prod-
uct is to be used, a shielded network cable (STP) may be appropriate or required. Any net-
work cables that are routed in outdoor environments or similar shall be shielded (STP) and
intended for their specific use. Make sure the midspan is properly grounded. See Electro-
magnetic Compatibility (EMC) for regulatory requirements.
Multi-connector – Terminal connector for connection of external equipment:
• Audio equipment
• Input/output (I/O) devices
• AC/DC power supply
When connecting external equipment to the Axis product, a multi-connector cable is required in
order to maintain the IP51 rating. The multi-connector cable can be purchased from your Axis
reseller. For more information, please see the User Manual available at www.axis.com
SD card slot – A standard or high capacity SD card (not included) can be used for local recording
with removable storage.
To insert and eject the SD card, the product's top cover must be removed, see Install an SD Card (not
included), on page 13.
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
AXIS P5544 Installation Guide