Publicité
Les langues disponibles
Les langues disponibles
NOTE: WHERE NOT EXPRESSLY INDICATED, THESE INSTRUCTIONS ARE REFERRED TO ALL MODELS
General information
In a few seconds Foggy is able to create a fog effect that makes it impossible to move within rooms, forcing the ill-
intentioned person to immediately search an escape route. Combined with an intrusion detection system, it completes
effectiveness of the detection through and "active" protection of the area.
The continual system monitoring always keeps liquid level, boiler temperature, battery status and network presence
under control; Foggy is also equipped with a safety thermostat that deactivates the system in case of overheating.
Harmless to persons and property
The fog created by Foggy is completely harmless and suitable for use in residential, commercial, industrial and
military field of application. It is ideal for protecting property that is sensitive and valuable such as what is found at
jewellers, electronics ands computer stores and warehouses.
The fog disperses without leaving any residue. Intense verifications, carried out at specialised analysis laboratories,
guarantee the non toxicity of this effect that is also used bylaw enforcement agencies for fire simulations.
Duration of the fog effect
It will take approximately 20 / 30 minutes to recuperate complete visibility. In order to obtain a fog effect that lasts
over time, it is possible to enable a particular function that activates a maintenance deployment impulse.
E
Connections
N
Foggy can be the natural completion of any installed intrusion detection system. It is pre-set with a series of free
inputs that allow interfacing with any control unit.
G
Foggy has an available equipping input that allows following the on/off status of the control unit in order to guarantee
that it cannot be activated while the system is shut off. Besides this, there is also a double consent that acts as a
guarantee against accidental activation of the fog generator. For example, it is possible to activate the pre-alarm
using the relay from the intrusion detection control unit and connect the actual alarm input to an autonomous sensor
in the environment protected by Foggy.
Besides these inputs, Foggy includes free contact control outputs dedicated to:
Anti-removal alarm, Liquid level, System disbursing, Technical malfunction with an indication on the display for No
network, Battery level, Battery failure, Pump malfunctioning, Board temperature, Boiler temperature.
FOGGY Dimensions
FOGGY 30
163
163 mm
FOGGY Fog generator
HOT COMPONENTS,
DANGER OF BURNS
264
264 mm
CAUTION! The caution indications highlight
procedures which if not observed or
partially observed could cause damage to
the device or the connected equipment.
FOGGY 50
165 mm
165 mm
- 36 -
354 mm
354 mm
Publicité
