Preparation - Twin-Star International 23MM1824 Manuel D'instructions

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Locate the Center Left Side Panel (B), Center Right
Side Panel (C), Center Front Panel (D), and set out
face down on a scratch-free surface.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Center Left Side Panel and Center Right
Side Panel snug to the Center Front Panel. Make
sure the Wood Dowels are seated in the pre-drilled
holes.
Connect the Center Left Side Panel (B), Center
Right Side Panel (C) and Center Front Panel (D)
with Connection Plate, tighten Screws (DD) through
the pre-drilled holes.
Hardware Used
CC Wood Dowel
DD Screw
2. Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Locate the Center Shelf (K) on the top of the
assembly from the step 1, as shown in diagram.
Make sure that dowels are seated into the pre-drilled
holes.
Using Bolts (AA) and Washers (BB) attach these
panels through pre-drilled holes in the mounting
blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Flat Washer
CC Wood Dowel
All manuals and user guides at all-guides.com
x 4
x 2
x 6
x 6
x 4
4
Fig. 1
D
CC
C
Fig. 2
K
CC
D
C
BB
AA
CC
B
DD
CC
B