Cooper Lighting Solutions Greengate RCPC Instructions D'installation page 4

RCPC Partition Control Interface
Wiring steps:
The RCPC ships with shunt jumpers installed across pin 1 and 2 of partition terminals J1-J4. The shunt jumpers must
●
remain installed for any room partition that is not used.
Connection of occupancy sensors is optional.
●
With system power off, start by wiring the partition sensor between Room A and Room B, IRTR A|B to J3. Connect Room
●
Controller or DLVP PM A wallstation and sensor (optional) via Cat 5.
Wire J2 next, partition sensor between Room B and Room C, IRTR B|C. Connect Room Controller or DLVP PM B
●
wallstation and sensor (optional) via Cat 5.
If Room C is applicable, wire J1 next, partition sensor between Room C and Room D, IRTR C|D. Connect Room Controller
●
or DLVP PM C wallstation and sensor (optional) via Cat 5.
Finally, if Room D is applicable, wire J4, partition sensor between Room D and Room A, IRTR C|D. Connect Room
●
Controller or DLVP PM D wallstation and sensor (optional) via Cat 5.
Refer to the wiring schematic and main PCBA diagrams below for connector locations and general wiring configuration used
to connect the RCPC partition control interface to associated Room Controller or DLVP Power Modules (DLVP PM).
WS OCC
D
Room
Controller
A
CAT5
Cables Partition
Switch
Room Room
Partition Open/Close
Controller Controller
A A
(Use only Partition
Wallstation Sensor
Switch or IRTR)
Typical J1-J4
4 www.cooperlighting.com
WS
+V SIG +V SIG
A A B
Room
Controller
CAT5
IRTR Cables
Connection
Room
Controller
Signals
B
Wallstation
OCC WS OCC
Room
Controller
B C
CAT5
Cables
Room Room Room
Controller Controller Controller
B C C
Sensor Wallstation Sensor
+V SIG +V SIG
B C C A
Room
Controller
D
Wallstation
WS OCC
Room
Controller
D
CAT5
Cables
Room
Controller
D
Sensor