Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The RCPC includes connectors for:
Applicable Wallstation (WS)
●
●
Optional Occupancy Sensor (OCC)
●
●
IRTR or Partition Switch (J1-J4)
●
●
Use only an IRTR or Partition Switch for each movable wall. The IRTR uses Pin 3 and 4 of the terminal block (J1-J4) and the
Partition Switch uses pins 1 and 2 of the terminal block (J1-J4).
The logic state for the Partition Switch is:
Partition Switch contact closed=Partition closed
●
●
Partition Switch contact open=Partition open
●
●
N
ote:
The RCPC ships with shunt jumpers installed across pin 1 and 2 of J1-J4. The shunt jumpers must remain installed for
any room partition that is not used.
General installation information:
Enclosure may be wall or ceiling mounted
●
●
Preconfigured with knockouts for field wiring or conduit
●
●
The RCPC partition control interface is a low-voltage device and the main PCBA is powered by Greengate bus,
●
●
no separate power supply is required. Note: IRTR sensors, if used, require a separate power supply for powering the
sensor electronics.
Dimensions and mounting:
Centrally locate the RCPC to minimize the length of cables required to connect to host control systems' wallstations,
occupancy sensors and room partition position sensors.
8.00"
203.2mm
View showing less cover
to show mounting holes
RCPC Partition Control Interface
Ø
.44"
11.18mm
2X
4.25"
107.9mm
Ø
.25"
6.35mm
2X
www.cooperlighting.com
3
Publicité
Table des Matières
