Signal Booster Specifications - Wilson Electronics Signal 4G Mode D'emploi

Signal Booster Specifications

Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (typical)
20 dB Bandwidth (MHz)
Typical
Maximum
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Power output for multiple
received channels (Uplink) dBm
No. Tones
2
3
4
5
6
Power output for multiple
received channels
(Downlinklink) dBm
No. Tones
2
3
4
5
6
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a
detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power
off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five)
such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily
removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the
rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users.
This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Need help?
698-716 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 Band12/17 700 Band13
MHz MHz
11.8 11.0
700 Band12/17 700 Band13
MHz MHz
29.5 31.6
33.9 33.9
700 Band12/17 700 Band13
MHz MHz
24.7 24.9
700 Band12/17 700 Band13
MHz MHz
-6.3 -6.5
700 Band12/17 700 Band13
MHz MHz
26.1 25.8
22.6 22.3
20.1 19.8
18.1 17.8
16.5 16.3
700 Band12/17 700 Band13
MHz MHz
-6.0 -5.9
-9.5 -9.4
-12.0 -11.9
-14.0 -13.9
-15.5 -15.4
www.wilsonpro.com
Signal 4G
460019
SMA
50 Ohms
800 1700/2100
MHz MHz
10.0 7.1
800 1700/2100
MHz MHz
38.4 81.8
40.6 85.4
800 1700
MHz MHz
24.1 25.6
800 2100
MHz MHz
-6.5 -7.7
800 1700
MHz MHz
21.0 21.3
17.5 17.8
15.0 15.3
13.0 13.4
11.5 11.8
800 2100
MHz MHz
-5.7 -6.8
-9.2 -10.3
-11.7 -12.8
-13.7 -14.7
-15.2 -16.3
5 dB nominal
> 40 dB
5 V / 4 A
Customer Support 866-294-1660
1900
MHz
8.6
1900
MHz
75.4
77.4
1900
MHz
25.0
1900
MHz
-5.8
1900
MHz
21.9
18.4
15.9
13.9
12.3
1900
MHz
-6.0
-9.5
-12.0
-14.0
-15.5
7