Signal Booster Specifications - Wilson Electronics PRO Serie Guide D'installation

Masquer les pouces Voir aussi pour PRO Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Signal Booster Specifications

Product Number
Model Number
FCC ID
IC ID
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Typical
Maximum
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Power output for multiple
received channels (Uplink) dBm
No. Tones
Power output for multiple
received channels
(Downlink) dBm
No. Tones
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or
disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only.
If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster
detects an oscillation, the Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal Booster will automatically resume
normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been
manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
Wilson Electronics products covered by U.S. patent(s) and pending application(s)
698-716 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700MHz Band12/17
59.1
700
Band12/17
MHz
29.9
34.4
700
Band12/17
MHz
20.4
700
Band12/17
MHz
-0.40
700
Band12/17
MHz
2
18.0
3
14.5
4
12.0
5
10.0
6
8.4
700
Band12/17
MHz
2
0.20
3
-3.30
4
-5.80
5
-7.70
6
-9.30
3301 East Deseret Drive, St. George, UT
www.wilsonelectronics.com | tech@wilsonelectronics.com
Copyright © 2016 Wilson Electronics. All rights reserved.
For patents go to: weboost.com/us/patents
Pro 70™- 50 Ohm
U465034
460027
PWO460027
4726A-460027
N-F emale
50 Ohm
700MHz Band13
800MHz
56.2
59.2
700
Band13
800
MHz
MHz
28.6
38.7
34.4
40.3
700
Band13
800
MHz
MHz
20.82
25.16
700
Band13
800
MHz
MHz
-2.10
-2.00
700
Band13
800
MHz
MHz
17.6
24.9
14.0
21.4
11.5
18.9
9.6
16.9
8.0
15.3
700
Band13
800
MHz
MHz
-2.20
-0.80
-5.70
-4.30
-8.20
-6.80
-10.10
-8.70
-11.70
-10.30
5 dB nominal
> 90 dB
110-240 V AC, 50-60 Hz, 20 W
1700/ 2100MHz
1900MHz
64.8
67.8
1700/2100
1900
MHz
MHz
82.6
81.8
85.0
85.9
1700
1900
MHz
MHz
23.0
21.42
1700
1900
MHz
MHz
0.90
-1.40
1700
1900
MHz
MHz
20.0
18.6
16.4
15.1
13.9
12.6
12.0
10.7
10.4
9.1
2100
1900
MHz
MHz
0.70
2.10
-2.80
-1.40
-5.30
-3.90
-7.20
-5.80
-8.80
-7.40

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Pro 70

Table des Matières