How To Make Ice Cubes; Some Useful Information And Advice; Hints And Ideas; How To Save Energy - AEG Electrolux S 64190 KA1 Mode D'emploi

GB
Foods can take over odours from each other. So it is
essential to put foods in closed dishes or wrap them
in cellophane, aluminium foil, grease-proof paper or cling
film before placing them into the refrigerator. This way
foods will keep their moisture e.g. vegetables will not dry
out after some days.

How to make ice cubes

To make ice cubes fill the enclosed ice cube tray with water
and put it to the frozen food compartment. Wetting the bot-
tom of the tray and setting thermostatic control knob to
maximum stage can shorten preparing time. After finishing
do not forget to reset the thermostatic control to the suit-
able stage.
Ready ice cubes can be taken out of the tray under running
water then twist or hit it.
Some useful information and
advice
The variable shelves are worth paying attention to,
which increases the usefulness of the fresh food com-
partment considerably. Rearranging the shelves is also possi-
ble when the door is open at an angle of 90°.
The inside configuration of the door makes rearranging the
door shelves as required possible.

Hints and ideas

In this chapter practical hints and ideas are given about how
to use the appliance to reach maximum energy saving and
there is environmental information about the appliance as
well.

How to save energy

The colder the ambient temperature of the appliance is
the less energy it uses.
Avoid putting the appliance in a sunny place and near
anything that gives off heat.
Be sure that the condenser and the compressor are well
ventilated. Do not cover the sections where ventilation
is.
Wrap products in tightly closing dishes or cling film to
avoid building up unnecessary frost.
Do not leave the door open longer than necessary and
avoid unnecessary openings.
50
All manuals and user guides at all-guides.com
This appliance does not contain gasses which could damage
the ozone layer, in either its refrigerant circuit or insulation
materials. The appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging the cooling
unit, especially at the rear near the heat exchanger.
Information on your local disposal sites may be obtained from
your municipal authorities.
The materials used on this appliance marked with the sympol

Maintenance

Defrosting

Bleeding part of the moisture of cooling chamber in form of
frost and ice goes with the operation of the refrigerator.
Thick frost and ice has an insulating effect, so it reduces cool-
ing efficiency as the temperature increases, it needs more
energy, at a certain thickness it does not allow the door of the
frozen food compartment to open, possibly the door can be
broken.
At this type of appliance defrosting fresh food compartment
is automatic without any external intervention.
The thermostatic control interrupts the operation of com-
pressor at regular intervals for more or less time - during this
cooling is interrupted - temperature of the fresh food com-
partment increases and defrosting occurs. After defrosting
the thermostatic control restarts operation of the system.
Melting water flows through defrost water outlet into the
evaporative tray maintained on the top of compressor and
evaporates due to warmth of it.
ing water gathered can cause earlier failure as it can go to
the insulating of the appliance.
When closing the door of the frozen food compartment
take care to move its blade in the direction of the arrow
to fit it to the lock properly.
Put foods into the appliance only in a closed dish.
Put warm foods into the appliance only when they are at
room temperature.
Keep the condenser clean at the back of the appliance.

The appliance and environment

are recyclable.
Check and clean the outlet of melting water coming
during defrosting regularly. If it is clogged the melt-