Pebaro 0221 Mode D'emploi page 5

Please read all available documentation (instruction of use and safety instructions)
carefully before using this product! We assume neither responsibility nor liability
for accidents, damages and malfunctions resulting from inobservance of these
guidelines.
The instructions have to be stored in a safe place and have to accompany the
product at all times, especially if the product gets passed on to a third party!
Attention!
This item is not suitable for children under the age of 14, because the attachments
become very hot. The stamp applicator must only be used under adult supervision.
Contents
Stamp applicator incl.
metal support stand
5 coloured films
1 hologram film
Stripe stamp
Calligraphy point for curvy writing
'Fine' writing point for fine lines
'Medium' writing point for medium lines
Before you begin stamping, find a suitable place to work and lay out the cutting
mat provided as a work surface. Select a suitable material (e.g. leather, synthetic
leather, wood, paper, cardboard or cloth) and place any film over it.
1. To prevent the film from slipping, fix it above and to the left using washi
tape. This can easily be removed again without damaging the film. Select
the right attachment and screw it into the thread of the stamp applicator.
2. Connect the device to the power mains and wait 3 - 4 minutes for the stamp
applicator to reach its working temperature.
3. Depending on which attachment you have selected, either use the stamp
applicator to write or draw on the film, holding it like a large pen. Or press the
full surface of the stamp attachment onto the film in order to stamp a certain
design. To write or draw, move over the film at a normal speed, or perhaps a
little slower; stamps work best if the attachment is a little loose, and if it is not
pressed down for too long. Just give it a try – practice makes perfect!
4. Then carefully pull the film away from the selected material
TIPS
» After laying the film on the object, and possibly taping it in place, a template or a
printout can also be fixed in place over it (again using washi tape), in order to
apply the design.
» Carefully lift the film to check if it has been transferred correctly, and repair any
spots that have not been transferred sufficiently.
EN
'Thick' writing point
for thick lines
Heart stamp
Star stamp
Flower stamp
Small circle stamp
Large circle stamp
Cutting mat