Operation; Charging The Battery; Important; Using The Battery - Oregon Professional Serie Manuel D'instructions Original

Operation

Charging the Battery

• Set up an Oregon 120V Professional Series
charger in a dry, indoor location that allows
airflow and is free of dirt and debris
• Connect the AC power cord of the charger to
the AC inlet on the charger
• Plug the AC power cord of the charger into
a grounded wall outlet Note: The charger's
LED indicator will show a power-on blink
sequence and then turn off
• Connect the DC plug to the battery
• Allow battery to charge
Approximate charging times
BX975: 0% to 100% capacity ~300 min
BX650: 0% to 100% capacity ~180 min
• During charging, the LED on the battery that
indicates the next level of charge will flash
LEDs below that level will stay lighted until
the battery is fully charged When the battery
is fully charged, all LEDs will go off and the
LED on the charger will change from flashing
green to solid green

IMPORTANT:

• If, during charging, the
ambient temperature is not within the
charging temperature range, the battery may
stop charging and will not start again until
the charger is reset To reset the charger,
disconnect the charger from the battery, allow
the indicator on the charger to turn off, and
reconnect the charger to the battery
• Disconnect battery from charger upon
reaching the desired charge

Using the Battery

• Due to shipping regulations, the battery
is shipped with a partial charge It is
recommended to fully charge the battery
before first use
• Check the battery charge state by pressing
and releasing the battery indicator button
Verify it has sufficient charge
• Place the battery in the 120V Professional
Series backpack, tool, implement, or
appliance
Battery Models BX975 and BX650
All manuals and user guides at all-guides.com
Operation
• Insert the black plug from the tool electrical
• Fully close the zippers on the backpack or
• During use, the battery charge state and any

Useful Tips

TO OPTIMIZE RUNTIME:
• Store the battery within the recommended
• Do not expose the battery to direct sunlight
• Recharge the battery at the end of every
• Before long-term storage, the battery charge
TO IMPROVE BATTERY RELIABILITY:
• Do not use the handle to hang the battery for
• Secure the battery from excessive shifting
• On an open trailer, orient the battery socket to
During normal use, the internal cells of the
battery generate heat in addition to warm or
hot working conditions This could cause the
battery to be above the charging temperature
when plugged in for charging To start charging
sooner, place the battery and charger in a cool
location with air flow around the battery
Batteries stored in cold locations may need to
be warmed to begin charging For a battery
that is below charging temperature, warm in a
heated space but do not place directly in front of
a heat source
cord into the battery socket Verify it is fully
seated
ensure the battery is latched in place in the
tool
faults will be indicated on the tool dashboard
Please refer to the tool instruction manual for
further information
temperature range
for an extended period of time
workday even if it was not fully discharged
state should show the 1 green LED or 2 green
LED indication If not, charge or discharge the
battery to that state before storing
storage
during transportation
the rear of the trailer to avoid damage to the
socket during travel
9