Operation; Applications - RIDGID R3205 Manuel D'utilisation

ASSEMBLY
WARNING:
7-1/4 in. blade is the maximum blade capacity of
the saw. Also, never use a blade that is too thick
to allow outer blade washer to engage with the
flat on the spindle. Larger blades will come in
contact with the blade guides, while thicker blades
will prevent blade screw from securing blade on
spindle. Either of these situations could result in a
serious accident.
NOTICE:
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop
before engaging spindle lock.
INSTALLING/REMOVING THE BLADE
See Figures 2 - 3, page 15.
 Unplug the saw.
 Depress and hold spindle lock.
 Remove blade screw by turning it counterclockwise
with the hex key, while keeping the spindle lock button
depressed.
 Remove outer blade washer ("D" washer).
 Wipe a drop of oil onto the inner flange bushing and outer
blade washer ("D" washer) where they contact blade.
 Retract the lower guard into the upper guard, making
sure the lower guard spring works properly, allowing the
guard to move freely.

OPERATION

DANGER:
Keep hands away from cutting area and the
blade. Keep your second hand on auxiliary
handle, or motor housing. If both hands are
holding the saw, they cannot be cut by the blade.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
All manuals and user guides at all-guides.com
 Check to see that the saw teeth and arrow on the saw
 Fit the saw blade inside the lower blade guard and onto
 Replace outer blade washer ("D" washer).
 Depress spindle lock and replace blade screw.
 Tighten blade screw securely by turning it clockwise with
To remove the blade:
 Unplug the saw.
 Depress and hold spindle lock.
 Remove blade screw by turning it counterclockwise with
 Remove outer blade washer ("D" washer).
 Lift lower blade guard.
 Remove blade.

APPLICATIONS

You may use this product for the purposes listed below:
 Cutting all types of wood products (lumber, plywood,
 Cross cutting/rip cutting wood products
 Bevel cutting wood products
 Pocket cutting wood products
8 — English
blade and the arrow on the lower guard are pointing in
the same direction.
NOTE: The saw teeth point upward at the front of the
saw as shown.
WARNING:
If inner flange bushing has been removed, replace
it before placing blade on spindle. Failure to do
so will prevent blade from tightening properly and
could result in serious personal injury.
the spindle.
the hex key.
NOTE: Never use a blade that is too thick to allow the
outer blade washer ("D" washer) to engage with the flat
on the spindle.
the provided hex key, while keeping the spindle lock
depressed.
paneling, composition board, and hard board)
WARNING:
Never use abrasive cut-off wheels of any kind with
this saw. Use of non wood cutting blades can result
in property damage or serious personal injury.