Connec�Vity Op�Ons; Indicator Light; Lndicator Light - LC-POWER LC-M35-UWQHD-120-C Mode D'emploi

7. Connec�vity Op�ons
1. Insert one end of the DP cable into your PC's graphics card. An HDMl cable
may also be used. HDMI cable is included.
2. Connect the other end of the cable to the corresponding connector on
your monitor.
Audio Output
3. Connect the power cable to your monitor then connect the other end to
your power source. It is recommended that you use a surge protector with
adequate voltage if a wall outlet cannot be reached directly.
4. Locate the power bu�on on the monitor and press it to turn the monitor on.
8. Light lndicator

lndicator Light

Solid blue light indicates power is on and the monitor is opera�ng normally.
Flashing blue light indicates no video source, no horizontal or ver�cal signal
has been detected or power is low.Please ensure your computer is on and
all video cables are fully inserted and/or connected.
DP Connectors
HDMI Connectors
Eng-7
Power Connector

Indicator light