Resetting The Unit; User Preferences - Danfoss HC6000 Notice D'utilisation

Resetting The Unit

GB
Before beginning the programming of the unit please press the
reset button using a non-metallic object (e.g. pencil/matchstick).
During programming if no buttons are pressed for two minutes
the unit will automatically go back to run mode. All changes
made will be saved.

User Preferences

Before programming the thermostat it is recommended that
the user preferences as regards clock display and temperature
scale are set.
Clock Display
Press both SELECT and
change display between AM/PM and 24 hour clock. Repeat to
return to original setting.
Temperature Scale
To select between Centigrade and Fahrenheit temperature
displays please follow the following steps:
1. Press SELECT and
to enter temperature display mode.
2. Press SELECT and FAN buttons for 2
seconds to change between Centigrade and
Fahrenheit display.
3. Press SELECT and
to change display back to time display mode
prior to programming.
4
All manuals and user guides at all-guides.com
buttons and hold for 2 seconds to
buttons for 2 seconds
buttons for 2 seconds
+
SELECT
+
SELECT FAN
+
SELECT