Danfoss HC6000 Notice D'utilisation page 7

Setting the time and temperatures events for
Days 6-7.
1. Press PROG repeatedly until 6 7 appears at
the bottom of the display.
2. Press + or – buttons to adjust event time.
3. Press PROG to advance to temperature
setting.
4. Press or
temperature.
5. Press + or – button to select required cooling
temperature.
OPTIONAL: If heating is not required, "Off " can be selected below 5°C.
If cooling is not required, "Off " can be selected above 37°C.
Press PROG button to move onto event 2 programming and
follow the steps above to programme event 2, 3 and 4.
Daily Use instructions
The operating mode of the thermostat can
be changed by pressing the SELECT button.
These thermostats are used in 4-pipe system
which allow heating or cooling to operate
all year round. The available modes are as follows:
Auto: The thermostat switches automatically between heating
and cooling to maintain the programmed temperatures.
Heat: Thermostat operates as heating thermostat only, starting
the heating when the room temperature falls to below the
wanted temperature.
All manuals and user guides at all-guides.com
buttons to adjust heating
GB
+ -
or
AUTO
HEAT
COOL
OFF
7