Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
1.
Grip the handle (A) firmly with one hand to allow easy operation of the
throttle lever (B).
2.
Press the lever gently. Adjust the sanding speed by increasing or
decreasing the pressure applied to the lever.
3.
Press the sandpaper sheet gently onto the workpiece. Slowly build up
speed and pressure as needed.
NOTICE! The friction between the sandpaper sheet and workpiece surface
will cause heat. Check the workpiece frequently to ensure that it does
not burn.
4.
When finished with the tool, turn off the air compressor, disconnect
the air hose and discharge any residual air remaining in the tool.
PRESSURE DROP
Apply the air consumption and pressure rate numbers to the tool' s air inlet,
not the compressor' s outlet. Calculate the pressure drop for your air supply
set-up and increase the compressor outlet pressure to compensate. Make
sure you do not exceed the maximum pressure for any part of your air
supply system.
Installing a pressure gauge at the tool inlet is the best way to measure the
air pressure and adjust the compressor' s output.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced by
an authorized technician. Only use identical replacement parts
when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool handles clean, dry and free from oil/grease at all times.
6.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
Visit www.princessauto.com for more information
3-3/4 x 9 in. Orbital Jitterbug Air Sander
8843815
9
Publicité
Table des Matières
