Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
4.
Do not cover the air vents.
5.
Disconnect the power source before installing or servicing the tool.
6.
Before using the tool on a workpiece, test the tool by running it at the
highest speed rating for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the
tool to determine the cause.
7.
Never force the tool. Excessive pressure could break the tool, resulting
in damage to your workpiece or serious personal injury. Excessive
pressure is the cause if your tool runs smoothly under no load, but
roughly under load.
8.
Keep hands and fingers away from the work area. Any part of body
contacting the tool' s working parts could cause an injury.
9.
Never touch the tool accessory or workpiece during or immediately after
use. They may be hot and could inflict a burn injury.
10. Do not place the tool down until the tool' s accessory has stopped moving.
The accessory may catch the surface of work material and wrench itself
free, causing injury to the user or others in the work area.
AIR TOOL PRECAUTIONS
1.
Use only clean and dry compressed air as a power source.
Contaminated or moist air will gradually damage the tool.
2.
Install an in-line shutoff valve or regulator to allow immediate control
over the air supply in an emergency, even if a hose is ruptured.
3.
Discontinue tool use if it does not work properly or air is leaking. Tag
or mark the tool as 'defective' or 'out of service' until repaired.
4.
Check the manufacturer' s maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated to never
exceed the maximum pressure rating of the tool (see Specifications).
Exceeding the maximum PSI rating can create a bursting hazard,
causing injury and property damage.
5.
Never use oxygen, combustible gas or any other bottled gas as a
power source. Any power source other than an air compressor could
cause an explosion and serious personal injury.
6.
Turn OFF the valve and discharge any remaining air pressure after each
use or before adjusting the tool.
Visit www.princessauto.com for more information
3-3/4 x 9 in. Orbital Jitterbug Air Sander
8843815
5
Publicité
Table des Matières
