Singer SWK 700WH Mode D'emploi page 3

All manuals and user guides at all-guides.com
INSTRUCTION FOR USE
Description of the appliance
6
7
8
OPERATION
Water fi lter placing
1. Open the lid by pressing the lid release button.
2. Place the fi lter between the two grooves near the spout at the front of the kettle.
3. Ensure that the fi lter is pressed down to the bottom of the grooves and fi ts correctly. Then close
the lid.
NOTE: Never leave the fi lter loose in the kettle. Never remove the fi lter while the kettle contains
hot water.
1. Open the lid and fi ll the kettle with water. Be sure that you close again the lid, other-
wise the automatic power cut-off cannot be put into effect, after the water starts boiling.
Caution: the water level must be between the MIN and MAX level as marked on the housing.
Less than MIN water may damage the heating element, while if water is overfi lled, boiling water
may overfl ow.
2. Place back the kettle on the Base and connect to the power supply. Position the kettle so that
the spout of the kettle is facing away from you.
3. Press down the On/off Switch. The indicator light will illuminate. Water begins to heat up. Do not
open the lid while the water is boiling.
4. Power will be cut off automatically and the On/off Switch will return to the off position, once the
water has been boiled. The indicator light will turn off.
5. The kettle can be used again after letting to cool down for about 15-20 seconds, provided the
kettle has been switched off automatically.
Safety system
This appliance has a safety system, which automatically switches off the heating element if the
appliance is inadvertently switched when empty or if it boils dry. In this case, let the appliance cool
down completely, before fi lling with water again.
2
1
3
4
5
3
ENGLISH
1. Lid
2. On/off switch
3. Handle
4. Indication light
5. Base
6. Lid opening button
7. Water level indication
8. Cord storage