neabot NoMo N2 Guide De L'utilisateur page 25

Care and Maintenance
Velcro
Remove
Install
Mop cloth fixing strip
Remove the Mop Cloth
As shown in the figure, press and hold the two snaps of the mop cloth
support, pull out the mop cloth support horizontally, and then tear off
the velcro to slide the mop cloth fixing strip out of the mop cloth fixing
slot.
Install the Mop Cloth
As shown in the figure, put the mop doth fixing strip in the mop cloth
fixing slot, attach the mop cloth to the velcro, and then push the mop
cloth support horizontally to install it on the robot.
Remove/Install the Disposable Mop Cloth
After removing the mop cloth support, tear off the velcro to remove
the disposable mop cloth.
Attach the disposable mop cloth to the velcro, and then replace the
mop cloth support to complete the installation.
Power-off and Restart/Restore the Factory Settings
If the buttons do not respond or the machine cannot be turned press
the reset button with a needle for 1 second to power off and restart.
Mop cloth fixing slot
22
Cleaning Sensors
It is recommended to use a clean, soft, dry cloth to wipe
each sensor gently every week to ensure the normal use
of the machine.
Cliff sensor*4
Infrared sensor*3
Charging electrode tip*2
Wall-mounted TOF sensor*1
Wall-mounted
TOF sensor
Infrared sensor
Charging
eletrode tip
Infrared sensor
Cliff sensor
Infrared sensor
Charging eletrode tip